00.6.  起重機的收藏/整體檢修以及報廢拆除

00.6.1. 起重機的停放

當收藏起重機時，注意不要停在其它作業的道路上。
確認沒有加載能量源被遺留在起重機上，如高壓容器、液壓儲壓器、電池等等。如果這些能量源自我釋放，將導致無法控制的危險情況。
確認可能出現的油料泄漏不會污染環境或者對環境造成危害。。
對于收藏的起重機進行規定的日常檢查。

00.6.2. 起重機的啟用

當將起重機從收藏狀態變成使用狀態時，仔細學習操作員指南。在使用之前，對起重機進行全面的保養。
除日常的檢查之外，對起重機進行長時間收藏后的相關程序。
檢查在液壓系統、發動機制動系統、變速箱等處的液面高度是否適當。
在首次運行中要小心駕駛，確認起重機運轉正常。

00.6.3. 整體檢修

在起重機保養期到達時，你必須考慮將其停止工作或者進行整體檢修。
整體檢修后的起重機應該與新的起重機沒有區別。新系統的建立要求為使用者準備單獨保養和操作指南。
負責進行檢修的團隊有責任準備新增功能的操作指南，與原有功能相關的新增功能應予特別注意。
當保養維修時，新增功能不能損害起重機原有的安全等級。
 

  名稱 日期 篇 頁碼
 綜合信息/定期保養 98-06-17 EH00-0024 37/38

 

00.6.4. 報廢拆除

當起重機最終從退役進行報廢拆除時，應時刻注意環保和安全問題。

在起重機被拆卸時或之后，都要注意起不能污染環境。

  不要將任何液體或者油料潑在地上

在拆卸中和拆卸后，確認沒有加載能量源被遺留在車上。這可能導致危險情況的出現。

  謹防危險能量的泄漏

了解哪些機械零件和液體是屬于有毒廢物一類的。按照在它們的具體要求處理這些材料。
定期保養 
動力單元

 

00.1. 動力單元……………………………………………………………………….…1
00.2. 動力單元………………………………………………………………….………3
00.3. 注意事項…………………………………………………….……………………5

00.1. 動力單元
康明斯QSX15--G。 見柴油機指導手冊

示意圖 30.  長基距起重機
 
示意圖 31.  短基距起重機
 

00.2. 動力單元
斯坦福HCI534E。 見發電機的安裝、柴油機組指導手冊

 
示意圖 32.  長基距起重機

示意圖 33.  短基距起重機
    5/5

 

01.3. 注意事項

00.6. Storing/complete overhau l the RTG and removing from
service
00.6.1. Storing the carrier
When storing the carrier, take care that it will not be in the way of other operations.
Makesurethatnochargedenergysorcesareleftonthecarrier,i.e.pressure vessels,hydraulic
pressure accumulators, electric batteries, etc. If left to discharge by themselves, these energy
sources may cause incontrollable danger situations.
Make sure that possible oil leaks from the carrier cannot harm or pollute the environment.
Carry out regular follow--up inspections on the stored carrier.
00.6.2. Taking the carrier back into use
When taking the carrier back into use from store, study the Operator’s Manual carefully.
Carry out a thorough maintenance on the carrier before taking into use.
In addition to normal inspections, carry out those procedures that are done after a long--time
storage.
Checkthatthefluidlevelsinthehydraulicsystem,the engines,the brakesystem, thetransmis-
sion, etc., are correct.
Drive cautiously at first to make sure that the carrier is working properly.
00.6.3. Complete overhaul
At the end of the carrier’s serviceable life you have to consider removing it from use or making
a complete overhaul.
A completely overhauled carrieris considered equal to a newone. The building up of newsys-
temsalso requiresthe preparationof separatemaintenance andoperation manualsfortheus-
ers.
The organization that carries out the overhaul is also responsible for preparing the operating
instructionsforthe newfunctions. In this connection, care must be taken to account for the be-
haviour of the new functions in connection to the remaining functions of the carrier.
The newfunctionsmust not deterioratethe carrier’soriginalsafetylevelofthe timewhen itwas
in service.
Description Date Group Page
General Information/Scheduled Mainteance 98- -06- -17 EH00- -0024 37/38
00.6.4. Removing from service
When the carrierisfinallyremoved from service, it should be taken apart keeping environmen-
tal and safety aspects in mind.
Take care that the carrier will not pollute the environment when being taken apart, or after-
wards.
Do not pour any fluids or oils to the ground.
Make sure that no charged energy sources are left during or after the dismantling. The may
lead to dangerous situations.
Beware of dangerous discharges of energy.
Investigate which machine parts and fluids are classified as toxic waste. Handle these materi-
als according to the specified instructions on their disposal.
Page Group Date Description
38/38 General Information/Scheduled Mainteance
00.7. Notes:
01 POWER UNIT
01.1. Power unit 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
01.2. Power unit 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
01.3. Notes: 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Description Date Group Page
Power Unit 03- -02- -10 EH01- -0014 1/5
01.1. Power unit
Cummins QSX15--G . See the Diesel Set Instruction Manual.
Cummins
Figure 30. Long frame RTG
Page Group Date Description
2/5 EH01- -0014 03- -02- -10 Power Unit
Cummins
Figure 31. Short frame RTG
Description Date Group Page
Power Unit 03- -02- -10 EH01- -0015 3/5
01.2. Power unit
Stamford HCI534E. See the generator Installation, Diesel Set Instruction Manual.
Stamford
Figure 32. Long frame RTG
Page Group Date Description
4/5 EH01- -0015 03- -02- -10 Power Unit
Stamford
Figure 33. Short frame RTG
Description Date Group Page
Power Unit 5/5
01.3. Notes: